Guides — sedan

Hyundai Elantra (2020) Rear Bumper

Joni Pham 发布

Hyundai Elantra (2020) Rear Bumper

Here's how to remove the rear bumper cover. 1. Open the trunk to remove both rear lights. 2. Remove the 6 plastic clips holding the top portion of the bumper. 3. In the wheel wells, remove the 4 fasteners holding the corner of bumper. 4. Underneath the trunk, the bumper is held by 3 clips. So remove those, then gently pull the bumper away from the car body.

阅读详细内容 →

Genesis G70 (2020) Rear Bumper

Joni Pham 发布

Genesis G70 (2020) Rear Bumper

Here's how to remove the rear bumper cover. 1. Underneath the car by the two exhausts, undo the two bottom plastic clips. 2. At the wheel wells start unclipping both corners. 3. Open trunk lid then remove the two black plastic covers along the top edge of the bumper. Remove the two horizontal and two vertical screws. 4. Then finish unclipping the bumper cover and pull away from the car body.

阅读详细内容 →

BMW 3-Series (2020) Rear Bumper

Micki Stone 发布

BMW 3-Series (2020) Rear Bumper

Here's how to remove the rear bumper cover. 1. Remove both rear tail lights. At the top of the bumper (where tail light mounts), remove the 10mm fasteners. At both lower corners of the rear bumper (by exhaust pipes), remove the three 8mm fasteners. At the bottom center of the rear bumper, remove the three T25 Torx fasteners.  2. Both sides of the fender well, remove two 8mm fasteners from wheel well liner. Then peel back wheel well liner and remove the T25 Torx fasteners. 3. Both sides, pull top corner of bumper out to unclip. Direction toward the rear, slowly...

阅读详细内容 →

Toyota Camry (2020) Rear Bumper

Micki Stone 发布

Toyota Camry (2020) Rear Bumper

Here's how to remove the rear bumper cover. 1. In the wheel wells, remove both mud flaps.  2. Open trunk lid then remove the black plastic covers hiding the  T10 Torx fasteners that holds the top of the bumper. 3. Remove the 4 plastic clips holding the bottom bumper. 4. Start unclipping the bumper from all sides and also unplug the parking sensors connector.

阅读详细内容 →

Honda Accord (2020) Rear Bumper

Joni Pham 发布

Honda Accord (2020) Rear Bumper

Here's how to remove the rear bumper cover. 1. In wheel well, remove both mud flaps to remove the lower corner portion of the bumper.  2. Open trunk lid then locate the two T30 torx fasteners holding the top portion of the bumper to the trunk. 3. Underneath the trunk, remove two plastic fasteners. ONLY the two middle ones. 4. With all fasteners removed, start pulling the bumper cover away from the car body. Work your way around to the tail lights for both sides. Then lift up and pull away.

阅读详细内容 →