Chevrolet Colorado (2008) Front Bumper Cover

Publié par Nghia Pham le

T-15 torx, 7mm and 10mm sockets.

Unplug fog lights connectors.
Remove grill under the hood (bonnet).
Remove the screws holding fender liner on both side of wheel well.

Here's how to remove the bumper.

  1. Peel fender liner to locate the (3) screws holding the bumper.
  2. On the bottom grill near the center there is an angled hole to reach with ratchet extension, remove 2 10mm bolt, one on each side.
  3. There are (4) T-15 bolts underneath, remove those.
  4. Final step is to pulled the middle area out first to loosen everything then worked each side.



Partager ce message

← Message plus ancien Message plus récent →


    Brad le

    Joe le

Laisser un commentaire