Guides

BMW 328i E90 (2007) Front Bumper Cover

Posted by Nghia Pham on

BMW 328i E90 (2007) Front Bumper Cover

Prep:Remove screws that attach the fender liner to the bumper.If you have headlamp washers, remove the hoses from the injectors. Here's how to remove the front bumper. Remove the (7) screws at the bottom. Peel the edge of the fender liner to expose the screw that hold the bumper. Remove the screws for both sides. Now open the hood and remove the (4) bolt that hold the upper part. Make sure to disconnect the fog lights connector.

Read more →

BMW X5 E70 Rear Bumper Cover

Posted by Nghia Pham on

BMW X5 E70 Rear Bumper Cover

Prep: Rear wheel arch, remove the plastic rivets holding the liner outer edges. Remove tail lights and reflector lights. Here's how to remove the rear bumper. Using plastic pry tool, peel back the wheel well molding to locate screws holding the bumper. Repeat on opposite side. The bottom portion is held together by (6) screws. Remove the screws behind the reflectors. The entire bumper's top portion is held by clips. So gently unclip and separate starting from tail light.

Read more →

BMW X5 E70 Front Bumper Cover

Posted by Nghia Pham on

BMW X5 E70 Front Bumper Cover

Prep: remove the (4) screws holding the skid plate at the bottom of bumper. Here's how to remove the bumper. Front of the radiator, open hood and locate the (5) screws holding the bumper's top portion. Gently peel back the liners to locate and remove the screws holding the two sides. Now bumper should only be held by clips. So start unclipping the top portion underneath headlights. To make unclipping easier, remove the two grills by fog lights.  

Read more →

BMW X3 E83 (2007) Rear Bumper Cover

Posted by Nghia Pham on

BMW X3 E83 (2007) Rear Bumper Cover

Tools: Socket 8mm,  Prep: Both sides, remove 2 bottom screws on the rear fender liner.  Here's how to remove the rear bumper. Separate the liner to remove the 2 screws holding the bumper far sides. In the top corner of same area, remove the T25 hex screw. Both sides. By the exhaust another 8mm screw holding the bottom. And the final two 10mm screws connected to the impact bar.

Read more →

BMW X3 E83 (2007) Front Bumper Cover

Posted by Nghia Pham on

BMW X3 E83 (2007) Front Bumper Cover

Prep: If you have headlamp washers, remove the injector and the cover. Now locate the fog lamps, remove trim in the doorway. Unscrew the screws for the plates. Unscrew the screws around the perimeter at the bottom. Here’s how to remove the bumper: Remove the top plastic shield above the kidney grill. There’s three screws that holds the top of the bumper. Remove front wheels to access behind the fender’s liner.  Two hex and one rivet holding the liner. Under the headlight, remove T-25 hex screw located behind the liner that hold the top right corner of the bumper. Under...

Read more →