Guides — toyota

Toyota Tacoma (1995–2004) Front Bumper Removal

Posted by Quan Nguyen on

Toyota Tacoma (1995–2004) Front Bumper Removal

Here's how to remove the front bumper cover. From underneath the truck, unplug the connector on the back side of your fog lights. Using a 17mm and a 12mm Socket, remove your skid plate mounting bolts (x6), then remove the skid plate. (Fig A)         Using a 10mm Socket, remove the lower Bumper Bolts (x6). (Fig B)         If your vehicle has fender flares, use a 10mm Socket to remove the fender flare bolts along the inside of your wheel well (6 per side). (Fig C)         Release enough of the...

Read more →

Toyota Tacoma (1995–2004) Rear Bumper Removal

Posted by Quan Nguyen on

Toyota Tacoma (1995–2004) Rear Bumper Removal

Here's how to remove the rear bumper cover. Before you start, unplug the lights from both sides of the license plate. They should turn down and pull out. 3/4 Wrench to hold the nut from moving while using the 3/4 socket on the top. This is in the middle of the bumper above the hitch. Use a flathead screw driver to pop up those little squares up from the inside (closest to the license plate) and lift up. They do not pop straight up. Lift the center round section of that pop-in thing to pop it out. In addition to...

Read more →

Toyota Camry (2020) Rear Bumper

Posted by Micki Stone on

Toyota Camry (2020) Rear Bumper

Here's how to remove the rear bumper cover. 1. In the wheel wells, remove both mud flaps.  2. Open trunk lid then remove the black plastic covers hiding the  T10 Torx fasteners that holds the top of the bumper. 3. Remove the 4 plastic clips holding the bottom bumper. 4. Start unclipping the bumper from all sides and also unplug the parking sensors connector.

Read more →

Toyota Camry (2020) Front Bumper

Posted by Micki Stone on

Toyota Camry (2020) Front Bumper

Prep: Open the hood and remove the upper grill cover. Here's how to remove the front bumper. Underneath the car, remove the 10mm screws holding the bottom portion of the bumper. Both right and left side edges, by the fender, remove the screws. Now go back to the top of the grill and remove all the screws. Final step is to gently pry the bumper away from the car and don't forget to unplug the fog lights connectors.

Read more →

Toyota Camry (1996) Rear Bumper

Posted by Nghia Pham on

Toyota Camry (1996) Rear Bumper

Prep:Remove both left and right hand side luggage trims. Here's how to remove the bumper. Remove the 7 clips, 2 bolts, and 6 nuts then pull bumper away from the vehicle.

Read more →