Guides — mercedes

Mercedes CLA250 (2014) Rear Bumper

Posted by Joni Pham on

Mercedes CLA250 (2014) Rear Bumper

Prep: Underneath the car's trunk, remove the cover. There's (4) expanding rivets. Open the trunk and storage compartment to remove the trim at the lip of the trunk. Now remove the left and right trims that run along the tail lights. Remove the left and right compartment covers. Here's how to remove the rear bumper cover. With (2) screws on each side and (2) screws in the middle, remove the all (6) screws holding the bottom portion of the bumper.  Continue to the fender liner, remove the rivets holding the liner, then move the liner aside to remove the (2) rivets...

Read more →

Mercedes CLA250 (2014) Front Bumper

Posted by Joni Pham on

Mercedes CLA250 (2014) Front Bumper

Instructions on removing front bumper cover. 1. We were able to do this on the ground without jacking up the car, but it can make life easier in later steps to have more ground clearance to get to certain parts. Be sure to support the car with jack stands if you decide to lift the front! To begin, open the hood and remove the (5) T25 Torx bolts along the top of the bumper. 2. Next you will need to lift the pictured plastic piece up to access the (1) remaining T25 Torx bolt on each side that holds the...

Read more →