Guides — front

Acura RDX 2020 Front Bumper Removal

Posted by Nghia Pham on

Acura RDX 2020 Front Bumper Removal

Here's how to remove the front bumper cover. Underneath the car remove the (2) screws and (7) plastic clips that hold the bottom part. On both sides of the wheel well, peel away the fender liners then remove the screws that hold the edges.  Then open the hood to remove the (6) screws that hold the top portion of the bumper. By the headlights area, now start unclipping the bumper. Also gently remove unclip the side tabs. Final step is to pull back the bumper and disconnect the harness.  

Read more →

Acura NSX 2020 Front Bumper Removal

Posted by Nghia Pham on

Acura NSX 2020 Front Bumper Removal

Prep: Under the hood, take out nine clips and remove the trim above the grille. Here's how to remove the front bumper cover. In the wheel wells, remove the screws and peel the fender liner to remove the (1) screw on each side that attach the bumper edges to the car body. Underneath the car, remove the (2) screws and take out (9) plastic clips. Carefully unclip the bumper from the edges, pulls the bumper forward, remove the connectors from the fog lights, and disconnected hoses to the headlights washer.

Read more →

Acura NSX 2020 Front Bumper Removal

Posted by Nghia Pham on

Acura NSX 2020 Front Bumper Removal

Prep:Remove front wheels to have access to the wheel well fenders. Here's how to remove the front bumper cover. Remove (3) fender liner plastic clips from both left and right hand wheels arches. Gently Pull fender liner back then remove (3) T30 bolts that secured the bumper side edges. Underneath the car, remove (24) T30 bolts that holds the bumper to skid guards & supports, then remove the (4) screws across the top of the bumper (located under Hood). Pull out the bumper at the wheel arch area to release it from the hooks. Final step is to disconnect the sensors...

Read more →

Toyota Tacoma (1995–2004) Front Bumper Removal

Posted by Quan Nguyen on

Toyota Tacoma (1995–2004) Front Bumper Removal

Here's how to remove the front bumper cover. From underneath the truck, unplug the connector on the back side of your fog lights. Using a 17mm and a 12mm Socket, remove your skid plate mounting bolts (x6), then remove the skid plate. (Fig A)         Using a 10mm Socket, remove the lower Bumper Bolts (x6). (Fig B)         If your vehicle has fender flares, use a 10mm Socket to remove the fender flare bolts along the inside of your wheel well (6 per side). (Fig C)         Release enough of the...

Read more →

Saab 9000 Aero 1997 Front Bumper Removal

Posted by Quan Nguyen on

Saab 9000 Aero 1997 Front Bumper Removal

Here's how to remove the front bumper cover. Move ALL the 10mm nuts that hold the Black plastic under tray parts to the bumper and the chassis. Pull off all the Black plastic under tray parts. Remove power connectors for Fog lights. Remove the front Indicators. Note: there are some 10mm nuts along the side (behind the indicator area) that hold the side of the bumper to the inner wing. Finally, laying under the car, you will see two large 17mm bolts on the front that hold the bumper assembly to the main front beam. Undo and pull these 2...

Read more →