Guides — exterior

Acura RDX 2020 Front Bumper Removal

Posted by Nghia Pham on

Acura RDX 2020 Front Bumper Removal

Here's how to remove the front bumper cover. Underneath the car remove the (2) screws and (7) plastic clips that hold the bottom part. On both sides of the wheel well, peel away the fender liners then remove the screws that hold the edges.  Then open the hood to remove the (6) screws that hold the top portion of the bumper. By the headlights area, now start unclipping the bumper. Also gently remove unclip the side tabs. Final step is to pull back the bumper and disconnect the harness.  

Read more →

Acura RDX 2020 Rear Bumper Removal

Posted by Nghia Pham on

Acura RDX 2020 Rear Bumper Removal

Here's how to remove the rear bumper cover. Open rear gate and locate the plastic covers that's hiding the two screws holding the upper part of the bumper. On the side rear fenders, remove screws to the liners where you can find the (3) screws holding edges of the bumpers. There's three bottom screws at the bottom. Gently pry the sides and with assistance slow remove the bumper and disconnect the parking sensors harness.

Read more →

Acura NSX 2020 Front Bumper Removal

Posted by Nghia Pham on

Acura NSX 2020 Front Bumper Removal

Prep: Under the hood, take out nine clips and remove the trim above the grille. Here's how to remove the front bumper cover. In the wheel wells, remove the screws and peel the fender liner to remove the (1) screw on each side that attach the bumper edges to the car body. Underneath the car, remove the (2) screws and take out (9) plastic clips. Carefully unclip the bumper from the edges, pulls the bumper forward, remove the connectors from the fog lights, and disconnected hoses to the headlights washer.

Read more →

Acura MDX 2020 Rear Bumper Removal

Posted by Nghia Pham on

Acura MDX 2020 Rear Bumper Removal

Prep: Remove the spare tire. Here's how to remove the rear bumper cover.Underneath the bumper, located between the rear fascia and the spare tire, remove the (5) bolts. On each side by the wheel-wells remove the screws behind the splash guard. There are (2) more bolts accessed by lifting the hatch, located at the corners of the hatch recess, covered by plastic snaps.

Read more →

Acura NSX 2020 Front Bumper Removal

Posted by Nghia Pham on

Acura NSX 2020 Front Bumper Removal

Prep:Remove front wheels to have access to the wheel well fenders. Here's how to remove the front bumper cover. Remove (3) fender liner plastic clips from both left and right hand wheels arches. Gently Pull fender liner back then remove (3) T30 bolts that secured the bumper side edges. Underneath the car, remove (24) T30 bolts that holds the bumper to skid guards & supports, then remove the (4) screws across the top of the bumper (located under Hood). Pull out the bumper at the wheel arch area to release it from the hooks. Final step is to disconnect the sensors...

Read more →