Guides — 2000

Toyota Tacoma (1995–2004) Front Bumper Removal

Posted by Quan Nguyen on

Toyota Tacoma (1995–2004) Front Bumper Removal

Here's how to remove the front bumper cover. From underneath the truck, unplug the connector on the back side of your fog lights. Using a 17mm and a 12mm Socket, remove your skid plate mounting bolts (x6), then remove the skid plate. (Fig A)         Using a 10mm Socket, remove the lower Bumper Bolts (x6). (Fig B)         If your vehicle has fender flares, use a 10mm Socket to remove the fender flare bolts along the inside of your wheel well (6 per side). (Fig C)         Release enough of the...

Read more →

Toyota Tacoma (1995–2004) Rear Bumper Removal

Posted by Quan Nguyen on

Toyota Tacoma (1995–2004) Rear Bumper Removal

Here's how to remove the rear bumper cover. Before you start, unplug the lights from both sides of the license plate. They should turn down and pull out. 3/4 Wrench to hold the nut from moving while using the 3/4 socket on the top. This is in the middle of the bumper above the hitch. Use a flathead screw driver to pop up those little squares up from the inside (closest to the license plate) and lift up. They do not pop straight up. Lift the center round section of that pop-in thing to pop it out. In addition to...

Read more →

Honda Civic (1996 - 2000) Front Bumper

Posted by Quan Nguyen on

Honda Civic (1996 - 2000) Front Bumper

Here's how to remove the front bumper. here’s an overview of the screws you’ll be removing. Remove these 5 plastic screws. On the bottom of the bumper, you’ll see two bolts holding it to the frame. In each wheel well, right at the corner where the bumper meets the fender, there should be a screw holding them together. You’ll have to peel/pull back the wheel well plastic a bit to get at the screw. The bumper should now be free to be removed  

Read more →

Honda Civic (1996 - 2000) Rear Bumper

Posted by Quan Nguyen on

Honda Civic (1996 - 2000) Rear Bumper

Here's how to remove the rear bumper. Remove the two screws on each side. The first one is right at the top of the side of each bumper. Remove the two clips on the underside of the bumper. Remove the 5 clips from the middle of the bumper. Pull.

Read more →